Getting mold off cheap carpet Utah
When getting mold off of your carpets you’ll probably be busing some kind of carpet mold remover. You must always read the instructions on the label before using the product, so be careful and read the instructions. Also, make sure you check the cheap carpet Utah manufactures guidelines, they’ll have some good tips also for removing old and nasty cheap carpet Utah mold.
Always test a small area of the carpet before using the product or natural solution before cleaning mold on your carpet. When cleaning mold, always wear protective goggles and even face-mask to protect the mold spores from damaging you and your families health.
Pull the cheap carpet Utah up from the floor, approximately 50 cm around the effected area, and leave to dry with a fan or a dehumidifier. Once dry, take s stiff brush and sweep more debris from the from and the back of the carpet. Now, vacuum all areas of the carpet as well as the floor where the carpet was situated. Apply your chosen anti-mold spray on the carpet and be sure to follow the instructions on the label. Scrub the carpet on bot sides, making sure the liquid solution absorbs all the way through, leaving the carpet to dry. Most anti-mold sprays should NOT be rinsed out, but always check the label.
Now apply the anti-fungal solution to the floor where the cheap carpet Utah was located, and leave the carpet to dry out. Re-apply the mold spray on all areas and let it dry out again. Make sure you continue to ventilate the room properly, open windows and even use fans to make sure the room is being thoroughly ventilated allowing air to fully circulate throughout the room. You can even use a dehumidifier for best results.
After cleaning, douse all the washable equipment that you used with an anti-fungal solution immediately. This will prevent the cheap carpet Utah mold spores from escaping onto other areas throughout your house. Make sure you wash your hands thoroughly.